Traditional set-downs & hobs rely on skilled hands, constant measuring and makeshift solutions.
Estenda replaces them with one modular system that cuts cycle times, simplifies installation and delivers consistent, high-quality concrete finishes.
At the core is the Estenda leg:
▪ MF250 and MF450 legs adjust from 150mm to 450mm
▪ 5mm trigger adjustment that locks in both directions, even after the formwork is in place
▪ Centre-line markers transfer set-out from base to top
▪ Open profile lets concrete fully encapsulate the leg, with no voids
▪ Built-in restraint with tie-wire access points, a Class 2 bar-chair base and optional side fixing for extra capacity
The Estenda rail system is cut to length then simply clicks and locks together, with a rebate depth range of 20 to 150mm. Engraved 10mm level guides mean the level is marked straight on the rail, with no tape measure needed. Concrete always finishes flush with the top of the rail, and the rail is uPVC and membrane-ready.
Attachments cover every set-down: L-cups in 50, 90, 120 and 150mm, the HobX metal hob system, the MF bar chair for a Class 2 finish, and 4m rail with joiners and corners.
Less labour. Less time. Fewer variables.
Product and installation information at estendasystems.com
Contact Estenda Systems on 1300 000 405 or info@estendasystems.com
Editorial note: This article and its content were produced by a sponsor.
